Website Banner
   
 
 
   
 
  • Drill Bushings
 
 
  • Drill Bushing Nuts
 
 
  • HOIST RINGS
 
 
  • LIFTING CLAMPS
 
 
  • TOOLING COMPONENTS
 
 
• LOCATING PINS AND BUSHINGS
 
 
• HYDRAULIC CLAMPS
 
 
• DE-STA-CO TOGGLE CLAMPS
 
 
• KAKUTA TOGGLE CLAMPS
 
     
   
 
  Headquarters
25520 Avenue Stanford,
Valencia,California 91355
 
  Toll Free Ordering:
855-361-1929
Toll Free Fax Ordering
855-361-1939
 
  Email Address :
sales.usbushing@gmail.com
 
 
     
     
   


TOOLING COMPONENTS
  • BALL LOCK MOUNTING SYSTEM


INSTALLATION INFO
Description: http://www.allamericanproducts.com/toolng/ballck_1.gif
Locates
The Ball Lock™ System accurately
positions your workpiece...to within
±.0005" repeatability, minimizing the
need to indicate your fixture.
Description: http://www.allamericanproducts.com/toolng/ballck_2.gif
Locks
The Ball Lock System securely holds
fixture plates to subplates with up to
20,000 lbs. of hold-down force per shank.
MOST COMMONLY ASKED QUESTIONS
Description: INFO
LOCATING SHANKS AND REPAIR KITS
LOCATING SHANKS
- Material:
    Shank/Bushing: 4340
    Liner: 52100
- Finish: Black Oxide
- Heat Treat:
    Shanks: RC 40-45
    Bushings: RC 50-54
    Liners: RC 62-64
- Stainless Steel Available in 13 and
  16mm sizes
- Available for High Temperature
  Applications (800°F Max)
REPAIR KITS
Each Kit Includes:
- Replacement Screw
- Locking Balls
- Drive Ball
- O-Ring
Any Ball Lock application requires at least two sets of shanks, receiver bushings and liners. The liners are placed into the fixture plate to insure extremely accurate positioning. If more than two shanks are required (to provide additional hold down force), omit the liner bushing so that these additional holes will not interfere with your primary locating holes.
Description: Locating Shank
U.S. Patent: #3,498,653, #4,135,415
Description: Repair Kit
RECEIVER BUSHINGS
  • FACE MOUNT
  • BACK MOUNT
- Material: 4340
- Finish: Black Oxide
- Heat Treat: RC 50-54
- Stainless Steel Available in 13 and
  16mm sizes
- Available for High Temperature
  Applications (800°F Max)
Two styles of receiver bushings are available. Generally, the face mount receiver bushing is utilized in blind hole applications (Slip Fit).
The back mount receiver bushing is used in through hole applications (Light Press Fit).
Description: Face Mount Receiver Bushing


Description: Back Mount Receiver Bushing
LINERS
- Material: 52100
- Finish: Black Oxide
- Heat Treat: RC 62-64
- Stainless Steel Available in 13 and
  16mm sizes
- Available for High Temperature
  Applications (800°F Max)
Locating repeatability will determine if one primary and one secondary or two primary liners are needed. With two primary liners, repeatability of ±.0005" can be maintained if the two holes for receiver bushings are held to a centerline distance of ±.0002" tolerance.
Description: Liners



© Copyright  2014 US Bushing,  All rights reserved.
Current Pageid = 882